sRPE & ACWR Calculator for Running
Mileage tells you how far you ran, not how hard it was. An easy 10 km and a 10 km tempo are very different loads. sRPE adds effort to the picture, so your acute:chronic ratio reflects intensity as well as distance.
Quick session load calculator
Session load: 360 AU
For your ACWR (acute:chronic ratio) with 28 days of history, use the full FitLoad calculator.
Example running week
- Easy run: 50 min × RPE 3 = 150 AU
- Intervals 6 × 800 m: 55 min × RPE 8 = 440 AU
- Long run: 110 min × RPE 6 = 660 AU
These three sessions add 1250 AU to the 7-day acute load.
How to use sRPE and ACWR in running
1. Rate the whole run
Give one RPE for the full session including warm-up and cool-down, about 30 minutes after you finish.
2. Log easy days honestly
Easy runs should be RPE 2–4. If they keep landing at 5–6, you're running them too fast.
3. Add cross-training
Cycling, strength work and swimming go in too — they still load your body.
4. Watch the ratio after race weeks
A race is a big single load. Expect ACWR to rise the following week and keep the next few days easy.
Reading the ACWR zones
- Under 0.8 — under-training; fitness may be dropping.
- 0.8–1.3 — commonly cited reference range, not a safety threshold.
- 1.3–1.5 — warning; load is rising fast.
- Over 1.5 — large spike relative to recent load; review with staff.
Acute load = last 7 days. Chronic load = 28-day total ÷ 4. ACWR = acute ÷ chronic. Learn more in the ACWR guide.
Coaching tips
- Building for a marathon? Keep ACWR between 0.8 and 1.3 and avoid two hard weeks back to back.
- A cutback week every 3–4 weeks keeps monotony low and chronic load steady.
- Pain in the Achilles, shin or knee plus an ACWR above 1.3 is a clear signal to back off.
Watch closely: Sudden jumps in long-run length or adding speed work and hills in the same week.